Automotive Paint and Supplies
autopaint@paintforcars.com

848-448-8186 Click for the BBB Business Review of this Auto Paint - in Toms River NJ

TCI Premium 2K Urethane Primer Surfacer w/Activator

TCI Premium 2K Urethane Primer Surfacer w/Activator
    Photos are intended for general color reference only. Refer to Color Chart for actual color samples.
     


    TCI 4200- Technical Information Sheet

    DESCRIPTION: 4200 Premium 2K Urethane Primer
    4200 is a two component acrylic urethane primer designed to provide ease of sanding as well as exceptional adhesion, film build, and cure time.

    INSTRUCTIONS:

    • Sand original finish with medium grit sandpaper
    • Clean all area with wax and grease remover
    • Surface should be clean and dry before applying product
    • Spray two or three medium coats of 4200, allowing each coat to flash to a dull appearance before applying the next coat.
    • For best results force dry or allow to air dry for one hour before sanding
    • 4200 can be block or machine sanded with P320 or P400, or wet sanded with P400 or P500 grit before applying topcoat

    GENERAL:

    Appearance -Gray Liquid
    Viscosity -Full Bodied
    Shelf Life -One Year (unopened)
    VOC -3.74 lb/gal (448 g/L)
    Pot Life -30 - 60 Minutes @ 75˚ F
    Product size
     -
    Primer - 4200 -One gallon or quart cans
     - Activator - 422 - Cone top quart or half pint cans

    PRODUCT MIXING:

    • Thoroughly mix four parts 4200 with one part of 422 activator
    • May be reduced 4:1:1 with urethane reducer if a lower viscosity is desired

     SUBSTRATES:

    •  Coat large bare metal, steel & aluminum areas with proper self-etching sealer
    •  Recommended substrate temperatures: 50˚ F - 100˚ F.

    GUN SET-UP TIP AIR PRESSURE
    Siphon Feed 1.8 - 2.0 mm 30 - 40 psi
    Gravity Feed 1.6 - 2.0 mm 25 - 40 psi
    HVLP (gravity) 1.6 - 2.0 mm 6 - 10 psi

    GUN CLEAN-UP:
    Clean equipment with a high quality lacquer thinner immediately after spraying

    TECHNICAL INFO: For additional technical information call (800-824-4999)

    SAFETY DATA: Refer to SDS for 4200 and 422

    FOR INDUSTRIAL USE ONLY.

    TO PROTECT AGAINST HARMFUL VAPOR & SPRAY WEAR A POSITIVE - PRESSURE SUPPLIED AIR RESPIRATOR (NIOSH APPROVED), EYEPROTECTION, GLOVES AND PROTECTIVE CLOTHING WHILE MIXING AND SPRAYING. FOLLOW SDS FOR APPROPRIATE SAFETY AND HEALTH INSTRUCTIONS

    DISCLAIMER: The information contained on this Technical Data Sheet is intended to assist you in product application. It is based on knowledge of general industry use, experience & research. Since conditions of storage, handling, and product use are not under our control,buyers must assume responsibility for suitability of the product for their specific purposes.


     

     


    © 1998-2015 PaintForCars.com

    **Always read, understand, and follow the product information and instructions provided. Product use is void where prohibited,
    and is intended for use only by professionals or under a professional's supervision. PaintForCars.com and Trinity 1945 Inc. are
    not responsible for adverse results while using our products. Liability, if any, shall not exceed a refund of the purchase price.